Site icon Crazmadsci

Bears: Lost Adventures Vol 1

Overview ~ Print issues/Areas of Improvement ~ Print Data ~ Where to find Files

Project Main: Lost Adventures Vol 1


RAWR! Check out these great bear models from the Lost Adventures vol 1 collection. These are yet another installment of my growing printed collection from this kickstarter. The one things I love about these models is their simplicity and yet detail of the tuffs of fur. These are by far the closest to actual gameplay size of a large monster for D&D as my other bears are small companions from the Reaper Miniature line.

The largest downside I image about these models is the difficulty of painting for the bear on the rock. I printed the base and the model attached so reaching to paint the rocks and bear underside will be a challenge for sure. But we will see how it turns out! I printed the standing bear in two pieces, base and bear. All in all these were great prints that came out super smoothly.

Print Issues/ Areas of Improvement

These printed models currently had no issues printing. If I was going to nitpick anything at all it would be that the standing bears feet are a bit rounded instead of flat which will require me to sand down slightly before gluing. I experienced no issues with supports and everything came out great.

Print Data

Printer: Phrozen Sonic Mini 4K
Resin: Elegoo ABS-Like Grey
Layer Height: 0.05 mm

Time to Print all components: 7 hr 5 min
Resin to Print: 60.1 g
Estimated Cost to Print: $2.46 or $1.23 per miniature

Where to Find these Files

These files can be currently found on the Lost Adventures Co Website and are apart of the Lost Adventures Vol 1 Kickstarter.

Lost Adventures Co: Website
Lost Adventures Vol 1: Late Pledge All-In $80.00
Individual Purchase: Bears: $6.99
Sculptor: Timothy Stetson

Exit mobile version