Project Main: Lost Adventures Vol 3 Test Printing
Overview
The Kobold Coalition is definitely the collection of this current Uncharted Lands, Lost Adventures Volume 3 Kickstarter I am most excited about. I have always had a love of Kobolds and the character of this collection far exceeds anything i’ve ever owned. These little humanoids have so much character and discussion since 5th edition Dungeons and Dragons has discussed, what is their own like? Well the Kobold Coalition is the perfect answer to that question.
In the collection of the Kobold Coalition you will gain a variety of buildings and terrain revolving around the home of the kobolds which look like so much fun. however I have had the pleasure of test printing the kobolds themselves and quite a large pet. Check out these fun creatures down below of what you have in store for yourself if you back this Kickstarter.
Disclaimer: These models are currently being tested and improved upon. These models are subject to change based on upon tester feedback and the discretion of Lost Adventures Co. before final release. I have been given permission to share some of my prints with my readers and am only a volunteer printer.
Print Settings
Due to the sheer size and number of the models tested in this collection so far I am going to add my print logs to individual write ups throughout the week to the site. Make sure to keep an eye out on the homepage to find out more specific information on how these models were printed.
Kobold’s printed in FDM
Printer: Prusa Mk3s
Filament: Esun PLA+
Layer Height: 0.08 mm
Build Plate Adhesion: Brim (just to be on the safe side)
Trash Guard Kobold
Printed Collection in both Resin & FDM
Kobold Scavengers
Kobold NPCs
T-Rex with Howdah
This T-Rex model comes with two different version heads, one with horns and one without for your choice when assembling the model. Printing this figure was extremely straight forward and one of the easiest if not the easiest to assemble models in my entire 3D printing hobby.
Total Print Time: 2 days 3 hours 26 minutes
Total Resin Used: 228 g
Total Cost to Print Miniature: $9.34
Where to Find these Files
These files can be currently found on the Lost Adventures Co Website and are apart of the Lost Adventures Vol 3 Kickstarter which is running until August 31st 2021.
Lost Adventures Co: Website