Giant Spider: Lost Adventures Vol 1

Overview ~ Printed Images ~ Print Data ~ Where to find Files

Overview

I have to say without a doubt that these spiders might be my favorite 3d printed spiders to date. Sculpted by Lee Stansbury of Mini Monster Mayhem makes me seriously want to find more models made by him. These models have unique poses, textures, and tell a fantastic story of predator vs prey.

While I did encounter some issues printing these figures most namely with the 3rd spider, “Giant Spider holding Prey”. Those issues were my own and due to poor bed adhesion. Although the spider did print and was barely holding on I do have some slight warping on the bottom of the base of the model.

All in All id say my largest complaint about this set is that I do believe it will be hard to paint the models since bases were printed with the models. Only time will tell though.

Printed Images

This did not print without it’s issues but overall was mostly based on the learning process of the resin I was using.

Print Data

Printer: Phrozen Sonic Mini 4K
Resin: Elegoo ABS-Like Grey
Layer Height: 0.05 mm

Time to Print all components: 17 hr 36 min
Resin to Print: 158.7 g (Printed with Carnivorous Plant which fell off supports)
Estimated Cost to Print: $6.51 (including plant) or $1.63 per miniature