Overview ~ Print issues/Areas of Improvement ~ Print Data ~ Where to find Files
Project Main: Lost Adventures Vol 2
Overview
This is the first of two sets of models for these figures. Below depicts four sages from the Heartwood Village of the Lost Adventures Vol 2 Kickstarter. What great sculpts are these. I know I’ll say it over and over but I am loving the fact that this Kickstarter has so many rare races with unique models. Some people in the 3d printing community may be familiar with the Turtlefolk Druid female model with the butterfly because it was a free test model during the Kickstarter. However for me the vulture bird has the most character. Normally I fall in love with more good aligned characters but this dark caster is just screaming for a great paint job and base to tell a story.
You also can’t forget the elephant folk or loxodon model which are still rare in the community. If I had a complaint about these models it would be the Death Cleric for being a bit too big. He for sure will need shrinking to sit on a standard 1″ base but also is going to be a ton of fun to paint.
Print Issues/ Areas of Improvement
I did not experience any issues printing these models.
Print Data
Printer: Phrozen Sonic Mini 4K
Resin: Elegoo ABS-Like Grey
Layer Height: 0.02 mm
Time to Print all components: 1 day 11 hr 8 min
Resin to Print: 126.4 g (Printed in two groups with the two Heartwood Wardens and Ettercaps)
Estimated Cost to Print: $1.91 or approximately $0.48
Where to Find these Files
These files can be currently found on the Lost Adventures Co Website and are apart of the Lost Adventures Vol 2 Kickstarter.
Lost Adventures Co: Website
Lost Adventures Vol 2: Late Pledge All-In $80.00
Individual Purchase: Heartwood Sages: Storytelling Pose $8.99
