Lizardfolk Miniature Print Data
Lizardmen, well here you have them what a great collection by Fat Dragon games. There is a great amount of variety, attack poses, and weapons. This is a great selection and overall printed well. Of all the models from the collection so far though these lizards do show a more advanced issue with overhangs as each scale of their backs and tails do overhang and can droop while printing. These will definitely go on my list of overhang testing for future improvements for sure. Overall not difficult prints and the detail is great for supportless models. I appreciate how easy it was to attach the weapons to these models. I also attempted to magnetize my first miniature base on the overhead spear figure… but that i’ll talk more about at a future time.
Layer Height: 0.08
Filament: Hatchbox PLA Silver
Adhesion: Weapons were printed with brims
Printed On Prusa i3 MK3s
Print Profile: Cura 4.6 “Offical_FDG_Cura_ender3_and5miniatures_4mm” from The FatDragonGames website
Orientation: Upright with base on build plate.
| File Name | Print Time | Estimated Material Used | Misc Notes |
|---|---|---|---|
| Lizard_Folk_01_Spear Raised | 1h 36 min | 4g | Spear attaches to the body really well. underside of model has some area for small overhang improvement around the booty. |
| Lizardfolk_01_SpearRaised_B | 24min | 0.8g | Spear printed pretty well. Spear handle does thin out a little bit around the hand closest to the tip of the spear |
| Lizard_Folk_02_Spear | 1 hr 46 min | 3.7g | Small overhang issues, on the underside of the scales on the back, almost all of them have a bit of clean up that is required. |
| Lizardfolk_03_Axe_A | 1 hr 45 min | 3.8g | Larger overhang issues on the underside of the armpit. Along with overhang on the scales of the back and tail. |
| Lizardfolk_03_Axe_B | 19 min | 0.5g | Axe came out well, axe head is not the smoothest of prints but is doing ok. |
| Lizardfolk_04_Bow | 1hr 40 min | 4.2g | Areas of retraction improvement on bow and quiver. Overhang on back and tail scales along with non bow hand from elbow to hand. |
| Lizardfolk_05 | Group Print* 13h | 32.2g with lizardfolk 6 and a piece of the Trashbeast C | Overhang issues again on shield and back. |
| Lizardfolk_05_Club_B | Club came out well, some tips did not come as well to a point but can come off as wear and tear on the club. | ||
| Lizardfolk_06 | Group Print* | Overhang issues are not as bad but still consistent. | |
| Lizardfolk_06_axe_B | 39 min | 1.2 | Axe tip almost became melty but survived. Some retraction on handle. |
Where to Find STLs
Dragonlock Miniature store via DrivethroughRPG. Vendor images are frome Fat Dragon Game Website.
- Lizardfolk Warriors 1 $4.99
- Lizardfolk Warrior 2 $4.99
One thought on “Lizardfolk Dragonlock Miniatures”