#overviewOverview ~ Printed Images ~ Print Data ~ Where to find Files
Project Main: Lost Adventures Vol 1
The Kobold Coalition is split up into three primary groups the NPCs, Scavengers, and Trash Guard. Here I will list my observations, print images and data associated with printing the Kobold Coalition Trashguard. Models are from the Uncharted Lands: Lost Adventures Volume 3 Kickstarter i’ve been test printing for.
What is truly special about this collection is that I have test printed this in both Filament and Resin prints. This really has inspired me to write a discussion about FDM vs Resin in miniature printing for a future writeup. Data for both types of printing are listed below. For side by side comparison Filament prints shown on left (light grey) and resin prints shown on right (dark grey).
I cannot articulate how much I truly love these little guys.
Special Note: Print Data for Shaman is located in Kobold Coalition NPCs.
I did have a few detachment of one model in the middle of my build plate. This was due to the suction force of the models on the build plate and printing again cleared up.
Printer: Phrozen Sonic Mini 4K
Resin: Epax Hard Grey
Layer Height: 0.05 mm
Time to Print all components: 6 hours 45 minutes
Resin to Print: 36.83 g
Estimated Cost to Print: $1.51 or $0.14 per miniature
Print Data Filament
Printer: Prusa MK3s
Filament: ESun Pla+ Grey
Layer Height: 0.08 mm
Time to Print all components: 5 hours 30 min
Filament to Print: 12.82 g
Estimated Cost to Print: $0.29 or $0.06 per miniature
Where to Find these Files
These files can be currently found as apart of the currently running Lost Adventures Volume 3 Kickstarter, which is running until August 31, 2021.
Lost Adventures Co: Website