This miniature was super easy to print and comes in several pieces for easy assembly. My favorite aspects are the paint stand which will be incredibly useful when painting and how the base will be easy to reach to paint. The mouth is open in the back of the front piece to more easily paint the inside of the gaping mouth and tongue (WIN!). I only used the Large Peg in this STL folder as it fit perfect in the model. There is also a small peg file which i did not use. I can’t wait to paint this guy!

Angry Ball of Eyes Miniature Print Data

Layer Height: 0.08
Printed On Prusa i3 MK3s
Filament: Hatchbox PLA Silver
Print Profile: Cura 4.6 “Offical_FDG_Cura_ender3_and5miniatures_4mm” from The FatDragonGames website

Abbreviations: Angry Ball of Eyes (ABE)

File NamePrint TimeEstimated Material UsedMisc Notes
ABE_Base3hr 3 min10gPrint was very nice. Some small nit picky 1st layers issues on bottom but unnoticeable
ABE_PaintStand2 hr 2 min5gDid not need to print at a fine layer height but I wasn’t paying attention
ABE_LargePeg13 min1gFit model perfectly. Did without a brim for a nice fit
ABE_Front and Back5 hr 36 min22gAlso printed without a brim since there was enough surface area on the model for a great adhesion and would keep the model cleaner. Teeth on front game out great.

Where to Find STLs

Dragonlock Miniature store via DrivethroughRPG. Vendor images are frome Fat Dragon Game Website.

  • Angry Ball of Eyes $2.99

Leave a Reply